Rotates the image 90 degrees counterclockwise See the section in this Manual describing ICC profiling of scanners, printers and film. It also searches for Firewire and SCSI scanners that have been added or removed. This command searches the network for scanners that have been added or removed since VueScan started. It uses the pixels inside the crop box in the Preview tab to compute these values. This command computes the optimal values for Input | RGB exposure and Input | Infrared exposure. The center of this focus area is displayed on the preview with a small circle with ‘Focus’ inside, and can also be changed with the Crop | Focus X offset and Crop | Focus Y offset options (options displayed only when the scanner is capable of this). This can dislodge particles from the light path. If you’ve got one or two narrow streaks appearing in the scan direction, try doing a scan with the scanner turned on its side. Sometimes the calibration data gets stored inside the scanner memory, sometimes it’s done once for every scan and sometimes VueScan stores the calibration data in a file when the “Scanner | Calibrate” command completes. When properly calibrated, the scanner should theoretically produce the same values for each pixel, if an image that is a single tone and color were scanned. The dark voltage level of each CCD element is slightly different.Each CCD element has a slightly different sensitivity to light.Lighting is usually uneven from one side of a scan to another.Generally, calibration compensates for three things: This command causes a scanner calibration on those scanners that support it. Input | Preview resolution is set to “Auto” or something less than 300 dpi, this may not work very well.Įjects film from a film scanner or paper from a document feeder. If you’ve created a preview but not a scan, the section of the preview inside the crop box is used, otherwise the most recent scan is used. You need to set Input | Media to “B/W text” for this to work. This command is for Optical Character Recognition (OCR) on the current image and copies the text to the clipboard. The section of the preview inside the crop box is used, If you’ve created a preview but not a scan, This command copies the current image to the clipboard. On Mac OS X, this command is in the VueScan menu. This command sets all options for the current scanner This command lets you save the current options settings to a file. This command lets you load the current options settings from a file. This command prints the current preview or scan. This command lets you control how the scanned image There are a number of commands that can be chosen from the menus in the menu bar which are described below.
0 Comments
Leave a Reply. |